Stainless Steel Filter Housing 7 X 20 Inch Filter (Threaded)

SKU: TQFH-LE-7-30 Category:

Description

This housing is a heavy-duty vessel constructed from 304  Stainless Steel. It is typically used as a “Side Stream” filter or a main “Point of Entry” unit for commercial buildings, factories, and high-end residential estates.

The Threaded designation usually refers to the 1-inch to 2-inch BSP ports, making it easy to integrate into standard rigid piping systems. Because of the 20-inch length, this unit is significantly more efficient at handling high flow rates with lower pressure drops compared to the shorter 10-inch model.

Key Features

  • Extended Service Life: Doubling the length from 10″ to 20″ effectively doubles the dirt-holding capacity, meaning half the maintenance frequency.

  • Swing-Bolt Lid: Most LE-7 series use a heavy-duty swing-bolt closure with a handle, allowing for high-pressure seals that are still easy to open by hand.

  • High-Pressure Rating: Unlike plastic housings that may crack at 6-8 Bar, these stainless units are often rated for 10 Bar (145 PSI) or higher.

  • Versatile Media: Can be fitted with a Size #2 Bag (if using a basket) or a 20″ Jumbo (4.5″) Cartridge depending on the internal manifold.


Technical Specifications

Feature Specification
Material Grade 304 (General Use) or 316L (Corrosive/Salt water)
Vessel Diameter 7″ (approx. 180mm)
Vessel Height 20″ (Media length)
Inlet/Outlet Ports 1″, 1.5″, or 2″ BSP Threaded
Max Pressure 10 Bar / 150 PSI (Standard)
Max Temperature Up to 120°C (Seal dependent)
Internal Capacity Holds 1 x 20″ Jumbo Cartridge or 1 x #2 Filter Bag
Drain & Vent 1/4″ or 1/2″ NPT/BSP for drainage and air bleed

Reviews

There are no reviews yet.

Be the first to review “Stainless Steel Filter Housing 7 X 20 Inch Filter (Threaded)”

Your email address will not be published. Required fields are marked *